How to determine your "A" dimension

 This chart is to help determine what series bearing you need. Before you begin your measurement please make sure to have your entire clutch assembly installed on the back of the motor and torqued down to the factory specifications, this includes Flywheel, Disc,Pressure Plate,Block Plate (if used) and Bellhousing. If your "A" dimension is less than 3" use the 1300 series bearing. If your "A" dimension is greater than 3" use the 1400 series bearing.The gap between the face of the bearing and the tip of the pressure plate finger should be between .100" & .200" for proper pressure plate release. To determine if you have the proper clearance subtract your "B" dimension from your "A" dimension and your equation should be within .100" & .200" anything outside of these parameters requires a piston change on the 1300 series units or a adjustment of the adjustment screw on the 1400 series units to fall back inline to the required parameters.